Design, Analysis, and Implementation of Solar Power Optimizer for DC Distribution System

Abstract—This paper proposes a high step-up solar power optimizer (SPO) that efficiently harvests maximum energy from a photovoltaic (PV) panel then outputs energy to a dc-microgrid. Its structure integrates coupled inductor and switched capacitor technologies to realize high step-up voltage gain. The leakage inductance energy of the coupled inductor can be recycled to reduce voltage stress and power losses. A low voltage rating and low-conduction resistance switch improves system efficiency by employing the incremental conductance method for the maximum power point tracking (MPPT) algorithm. Because of its high tracking accuracy, the method is widely used in the energy harvesting of PV systems. laboratory prototypes of the proposed SPO that have an input voltage range of 20 to 40 V and a maximum PV output power of 400 V/300 W are applied. The highest PV power conversion efficiency is 96.7%. The maximum MPPT accuracy is 99.9%, and the full load average MPPT accuracy is 97.8%.

(Index Terms—High step-up voltage gain, maximu tracking (MPPT), solar power optimizer (SPO).)

Analysis, Design, and Experimental Results of a Novel Soft-Switching Snubberless Current-Fed Half-Bridge Front-End Converter-Based PV Inverter

Abstract—This paper proposes a new novel snubberless currentfed half-bridge front-end isolated dc/dc converter-based inverter for photovoltaic applications. It is suitable for grid-tied (utility interface) as well as off-grid (standalone) application based on the mode of control. The proposed converter attains clamping of the device voltage by secondary modulation, thus eliminating the need of snubber or active-clamp. Zero-current switching or natural commutation of primary devices and zero-voltage switching of secondary devices is achieved. Soft-switching is inherent owing to the proposed secondary modulation and is maintained during wide variation in voltage and power transfer capacity and thus is suitable for photovoltaic (PV) applications. Primary device voltage is clamped at reflected output voltage, and secondary device voltage is clamped at output voltage. Steady-state operation and analysis, and design procedure are presented. Simulation results using PSIM 9.0 are given to verify the proposed analysis and design. An experimental converter prototype rated at 200 W has been designed, built, and tested in the laboratory to verify and demonstrate the converter performance over wide variations in input voltage and output power for PV applications. The proposed converter is a true isolated boost converter and has higher voltage conversion (boost) ratio compared to the conventional active-clamped converter.

(Index Terms—Current-fed converter, high frequency, photovoltaic (PV) inverter, renewable energy system, soft-switching.)